LSI 3ware SAS 9750-8i Uživatelská příručka stáhnout pdf (Strana 285)

Error and Notification Messages

www.lsi.com/channel/products 273

Cause

The controller has detected and corrected a memory ECC error.

Action

None required.

If errors persist, contact technical support at

http://www.lsi.com/channel/ContactUs

003A Drive power on reset detected

Event Type

Error

Cause

The controller has detected that a drive has lost power and then restarted. The

controller may degrade the unit if it is a redundant unit (non-redundant units

cannot be degraded).

Action

If this drive was the only one to lose power, check the cable connections.

Also, check that your power supply is adequate for the type and number of

devices attached to it.

See Also

For troubleshooting information and a link to drive manufacturer diagnostic

utilities, search the LSI Knowledge Base for keyword 14927 (use the

Advanced Search) at

https://selfservice.lsi.com/service/main.jsp

003B Rebuild paused

Event Type

Information

Cause

The rebuild operation is paused.

Rebuilds are normally paused for two (formerly ten) minutes after a system

first boots up and during non-scheduled times when scheduling is enabled.

Disabling or modifying the schedule with 3DM 2 or CLI will allow the

rebuild to resume.

1 2 ... 280 281 282 283 284 285 286 287 288 289 290 ... 341 342

Komentáře k této Příručce

Vikivzn 04 Jan 2024 | 17:05:44

urenrjrjkvnm

Evazoy 07 Jan 2024 | 01:42:43

Med

Renatimzn 07 Jan 2024 | 09:55:43

urenrjrjkvnm

Davidvmm 10 Jan 2024 | 11:36:21

coin

Davidefb 11 Jan 2024 | 11:24:30

coin

Viktorijsw 11 Jan 2024 | 19:38:33

Cinema

LSI 3ware SAS 9750-8i Uživatelská příručka Strana 285

Komentáře k této Příručce