LSI 3ware SAS 9750-8i Uživatelská příručka Strana 137

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 342
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 136
Changing An Existing Configuration by Migrating
www.lsi.com/channel/products 125
Changing RAID Level
You can use migrate to change the RAID level of an existing unit while the
unit is online, without experiencing any data loss. When you change a RAID
level, you may also add one or more drives to the unit. You can also migrate to
change the unit's stripe size. For example, a four-drive RAID 5 with a 64KB
stripe size can be migrated to a four-drive RAID 5 with 256KB stripe size.
The steps below describe how to change a RAID level in 3DM 2.
To change the RAID level of a unit
1 In 3DM 2, choose
Management > Maintenance.
2 In the Unit Maintenance table on the Maintenance Page, select the unit for
which you wish to change the RAID level, by checking the box next to
the Unit ID.
Note: Rapid RAID Recovery will be disabled on any unit that is migrated.
Warning: If you are booted from a mirror (RAID 1 unit), never split it into 2 single
(identical) drives. Once the unit is split, any pending writes cannot be written to the
second drive. In addition, the file system on the drive will not be clean. Instead, shut
down the system, replace one of the drives, and start the rebuild from 3BM.
Note: You can only migrate a unit to a RAID level that has the same or more
capacity as the existing one. A four-drive RAID 5 unit can migrate to a four-drive
RAID 0, but a three-drive RAID 0 unit cannot migrate to a three-drive RAID 5,
without adding another drive, due to the need for additional storage capacity for
parity bits.
Note: Once migration starts, the unit stays in the migrating state until the migration
process is complete. The migration process cannot be aborted, and must be
allowed to finish before a rebuild or verify to the unit is permitted.
Warning: It is important that you allow migration to complete before removing any
drives that are involved in the migration. Removing drives from the unit during
migration may cause the migration process to stop, and can jeopardize the safety of
your data.
Zobrazit stránku 136
1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 341 342

Komentáře k této Příručce

Vikivzn 04 Jan 2024 | 17:05:44

urenrjrjkvnm

Evazoy 07 Jan 2024 | 01:42:43

Med

Renatimzn 07 Jan 2024 | 09:55:43

urenrjrjkvnm

Davidvmm 10 Jan 2024 | 11:36:21

coin

Davidefb 11 Jan 2024 | 11:24:30

coin

Viktorijsw 11 Jan 2024 | 19:38:33

Cinema