LSI 3ware SAS 9750-8i Uživatelská příručka Strana 101

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 342
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 100
Changing the Phy Link Speed
www.lsi.com/channel/products 89
Changing the Phy Link Speed
You can change the link speed between the controller and an expander or
between the controller and a drive that is directly connected to the controller.
Typically, the phy link speed is set to Auto. If desired for compatibility,
troubleshooting or performance analysis, you can specify a specific link speed
(1.5, 3.0, or 6.0 Gbps).
To change the phy link speed in 3DM 2
1 On the Controller Phy Summary page, identify the phy device for which
you wish to change the link speed. Direct-attached drives are identified by
their VPort ID.
2In the
Link Control drop-down menu, select the desired speed: 6 Gbps, 3
Gbps, 1.5 Gbps, or Auto.
The link speed is now reset.
For details about the information displayed on this screen, see “Controller
Phy Summary page” on page 210.
Figure 39. Controller Phy Summary page
Zobrazit stránku 100
1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 341 342

Komentáře k této Příručce

Vikivzn 04 Jan 2024 | 17:05:44

urenrjrjkvnm

Evazoy 07 Jan 2024 | 01:42:43

Med

Renatimzn 07 Jan 2024 | 09:55:43

urenrjrjkvnm

Davidvmm 10 Jan 2024 | 11:36:21

coin

Davidefb 11 Jan 2024 | 11:24:30

coin

Viktorijsw 11 Jan 2024 | 19:38:33

Cinema