LSI 3ware SAS 9750-8i Uživatelská příručka stáhnout pdf (Strana 208)

Enclosure Management

196 3ware SATA+SAS RAID Controller Card Software User Guide, Version 10.0

Working with Enclosure Alarms

Some enclosures provide an alarm that turns on when a RAID unit becomes

degraded or goes offline, or when a drive has failed. (Specific use of the alarm

feature may vary somewhat, depending on the enclosure.)

If you have an enclosure with an audio alarm, you can turn the alarm

Off

when it sounds, using 3DM 2, 3BM, or the CLI. If the enclosure supports

muting, you can also mute and unmute the alarm in 3DM 2 or the CLI.

Note that you cannot turn an enclosure alarm on. Alarms are only turned on

(activated) when an error condition has been detected for a drive or RAID

unit. To view any error conditions that may have caused the enclosure alarm

to go off, see the

3DM 2 Alarms page. Status information about supported

enclosures is also available on the

3DM 2 Enclosure Details page. (You can

also use the CLI

/cx show alarms command, or check the status of the RAID

unit in 3BM.)

Muting an alarm provides the ability to silence the alarm, without turning it

off completely. You can also set the alarm to Mute in advance, if you do not

want the alarm to sound. When the alarm audibility is set to

Mute and the

alarm turns on, the word

Activated continues to display in the Status column

of the Audio Alarm Summary on the 3DM 2 Enclosure Details page, as

shown in Figure 85.

Note: Enclosure alarm support is based on the SES protocol.

9750 controllers support enclosure audio alarm for enclosures with expanders and

C backplanes that support the SES-2 protocol.

However, enclosure alarm support depends on the capabilities of the specific

enclosure or backplane. Not all enclosures provide an audio alarm, and for those

that do, not all provide both the On/Off and Mute/Unmute feature.

For details about what specific features are provided with your enclosure, see the

documentation that came with the enclosure or backplane.

Tip: Be sure you have the most recent firmware for the enclosure. If the alarm

feature does not work as anticipated, contact the manufacturer for updated

firmware.

Supported enclosures are listed at

http://www.lsi.com/channel/support/marketing_resources, through the Data &

Interoperability tab.

Additional support information is available in the LSI Knowledge Base, at this

website: https://selfservice.lsi.com/service/main.jsp.

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 341 342

Komentáře k této Příručce

Vikivzn 04 Jan 2024 | 17:05:44

urenrjrjkvnm

Evazoy 07 Jan 2024 | 01:42:43

Med

Renatimzn 07 Jan 2024 | 09:55:43

urenrjrjkvnm

Davidvmm 10 Jan 2024 | 11:36:21

coin

Davidefb 11 Jan 2024 | 11:24:30

coin

Viktorijsw 11 Jan 2024 | 19:38:33

Cinema

LSI 3ware SAS 9750-8i Uživatelská příručka Strana 208

Komentáře k této Příručce