LSI MegaRAID SCSI 320-2 RAID Controller Series 518 Uživatelský manuál stáhnout pdf (Strana 108)

7-14 Installing and Conﬁguring Clusters

• Create a small partition [Use a minimum of 50 Mbytes as a quorum

disk. Windows 2000 generally recommends a quorum disk to be 500

Mbytes.]

• Dedicate a separate disk for a quorum resource. The failure of the

quorum disk would cause the entire cluster to fail; therefore,

Windows 2000 strongly recommends that you use a volume on a

RAID disk array.

During the Cluster Service installation, you have to provide the drive

letter for the quorum disk.

Note: For our example, we use the letter E for the quorum disk

drive letter.

7.4.11 Conﬁguring Shared Disks

Perform the following steps to conﬁgure the shared disks:

1. Right-click on My Computer.

2. Click on Manage, then click on Storage.

3. Double-click on Disk Management.

4. Make sure that all shared disks are formatted as NTFS and are

designated as Basic. If you connect a new drive, the Write Signature

and Upgrade Disk Wizard starts automatically.

If this occurs, click on Next to go through the wizard. The wizard sets

the disk to dynamic, but you can uncheck it at this point to set it to

basic.

To reset the disk to Basic, right-click on Disk # (where # identiﬁes

the disk that you are working with) and click on Revert to Basic

Disk.

5. Right-click on unallocated disk space.

6. Click on Create Partition…

The Create Partition Wizard begins.

7. Click on Next twice.

8. Enter the desired partition size in Mbytes and click on Next.

9. Accept the default drive letter assignment by clicking on Next.

10. Click on Next to format and create a partition.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 157 158

Žádné komentáře

LSI MegaRAID SCSI 320-2 RAID Controller Series 518 Uživatelský manuál Strana 108